
Rail Slider Installation
Front
Follow steps (1) and (2) in sequence to install the rail slider.
Required tool
Small
(2)
Frame
Cap screw (small)
Cap screw (small)
(1)
Rail slider
Control box
If the screw holes for the small cap screws do not line up, loosen all screws at the locations shown in the figure.
While loosened, line up the screw holes and secure in place with the small cap screws, then tighten the loosened screws.
Top View
Stand leg
Loosen
(Screws lined up in
the vertical direction)
Frame
Rail slider
Cap screw (small)
Installing the Sensor and the Small Retainer
Required tool
Small
Stay
Cap screw (medium)
Cable retainer (small)
Affix to the rear surface of the stand and secure the sensor cable in place.
Orientation of the retainer (small)
680 mm ±20 mm
Align by placing the gauge packed with the TU against this.
Open the sensor to the front and back as shown, and fit it onto the stay.
Sensor cable
7