155

Overview Connections VS-700C Console VS-700R I/O Fantom VS Appendix

Installing the ARX Expansion Board

Up to one optional Expansion Board (ARX series; sold separately) can be installed in the VS-700R.

For details on ARX expansion boards, refer to the owner’s manual of your ARX expansion board.

For details on the ARX expansion editor (plug-in), refer to the online manual for the editor (plug-in).
The ARX expansion board’s ports have the following names.
• To avoid the risk of damage to internal components that can be caused by static electricity, please carefully observe
the following whenever you handle the board.
• Before you touch the board, always first grasp a metal object (such as a water pipe), so you are sure that any
static electricity you might have been carrying has been discharged.
• When handling the board, grasp it only by its edges. Avoid touching any of the electronic components or
connectors.
• Save the bag in which the board was originally shipped, and put the board back into it whenever you need to
store or transport it.
• Use a Phillips screwdriver that is suitable for the size of the screw (a number 2 screwdriver). If an unsuitable screwdriver
is used, the head of the screw may be stripped.
• To remove a screw, rotate the screwdriver counter-clockwise. To tighten the screws, rotate the screwdriver clockwise.

fig.exp01.eps

• When installing Expansion Board, remove only the specified screws.
• Be careful that the screws you remove do not drop into the interior of the VS-700R.
• Do not leave the bottom cover removed. After installation of the Expansion Board is
complete, be sure to replace the cover.
• Be careful not to cut your hand on the opening for installing the board.
• Do not touch any of the printed circuit pathways or connection terminals.
• Never use excessive force when installing a circuit board. If it doesn’t fit properly on the first attempt, remove the
board and try again.
• When circuit board installation is complete, double-check your work.
• Always turn the unit off and unplug the power cord before attempting installation of the circuit board (ARX series).
• Install only the specified circuit board (ARX series). Remove only the specified screws.

Port settings (MIDI input and audio output)

Port Name

MIDI Out Port ARX
Audio In Port ARX

Cautions When Installing an Expansion Board

tightenloosen

VS-700_r_e.book 155 ページ ２００８年１１月２０日　木曜日　午後２時２８分