33
CHANNEL STRIP Section
Overview Connections VS-700C Console VS-700R I/O Fantom VS Appendix
Depending on the conditions in which you use the VS-700, the touch sensitivity of the faders may not
work as you expect, or the motor may operate incorrectly when you’re operating the fader. If this occurs,
adjust the touch sensitivity as follows.
1. Close SONAR.
2. While holding down the [SHIFT] button and [CTRL] button, press the [MUTE] button of
the audio output section.
The current sensitivity setting will be shown in the LCD display, and you’ll be in sensitivity adjustment
mode.
fig.7a.eps_50
A. Fader Touch Sensitivity (0–127)
Higher values will increase the touch sensitivity; lower values will make it less responsive. At a
setting of 0, touch sensitivity will be disabled.
B. Touch sensitivity monitor
This will indicate “ON” if touch sensitivity activates when you touch the fader, and will return to
“OFF” when you remove your finger.
3. Turn the jog wheel to adjust “Fader Touch Sensitivity” in a range of 0–127.
Adjust this setting so that the touch sensitivity monitor indication in the LCD display changes from
“OFF” to “ON” when you touch each fader. Increase the value if the indication fails to turn “ON” when
you touch a fader; decrease the value if the indication turns “ON” when you merely bring your finger
near the fader.
The “Fader Touch Sensitivity” setting is common to all faders.
4. When you’ve finished making settings, hold down the [SHIFT] button and [CTRL]
button and press the [MUTE] button of the audio output section.
You’ll exit sensitivity adjustment mode, and return to the previous screen.

Adjusting the Touch Sensitivity of the Faders

Fader Touch Sensitivity:100
OFF OFF OFF OFF
Rotate JOG to adjust sensitivity
OFF OFF OFF OFF OFF
AB
VS-700_r_e.book 33ページ ２００８年１１月２０日　木曜日　午後２時２８分