SATA II/ATA 133 PCIe Card RC216 | User Manual | |
|
|
|
changing the jumper setting on the PCIe SATA II 300 + PATA Raid Card that allows you to select between external and internal ports to use. By default, Port CON1 & CON2 are working.
Hardware Installation
1.Turn Off the power to your computer.
2.Unplug the power cord and remove your computer’s cover.
3.Remove the slot bracket from an available PCIe slot.
4.To install the bard, carefully align the card’s bus connector with the selected PCIe slot on the motherboard. Push the board down firmly.
5.Attach your internal or external devices to the PCIe SATA II 300 + PATA Raid Card.
6.Replace the slot bracket’s holding screw to secure the card.
7.Replace the computer cover and reconnect the power cord.
RAID Arrays
RAID Arrays are setup in the PCIe SATA II 300 + PATA Raid Card’s BIOS. There are four configurations supported:
RAID level/Type | Configurations |
RAID 0 | Disk Striping |
RAID 1 | Disk Mirroring |
Number of disks needed
2 or 3 or 4
2
5
