3. Installation
3.2. Power Supply Wiring and Grounding
The RX1501 supports a single power supply, power module 1 (PM1). Power connections are located on the PM1 module face plate. An optional chassis ground connection is located on the front panel as shown in Figure 2.2, “Front View - RX1501”.
RX1501 products can be equipped with either a Phillips Screw Terminal Block or a Phoenix Plug Terminal Block. The Phillips Screw Terminal Block has Phillips screws with compression plates, allowing either bare wire connections or crimped terminal lugs. We recommend the use of #6 size ring lugs to ensure secure, reliable connections under severe shock or vibration. Both terminal blocks have a safety cover, secured with two Phillips screws, which must be removed to make connections. The safety cover must be
For AC and DC power supply wiring examples, refer to Section 3.2.4, “AC Power Supply Wiring Example” and Section 3.2.5, “DC Power Supply WiringExample ”.
The RX1501 has one (1) power supply installed. Service personnel must isolate all power supplies prior to servicing.
3.2.1. Connectors for HI and HIP Power Modules
Figure 3.8. Screw Terminal Power | Figure 3.9. Pluggable Phoenix Power |
Connector for HI Power Module | Connector for HIP Power Module |
3.2.2. Connectors for 24, 24P, 48, and 48P Power Modules
Figure 3.10. Screw Terminal Power | Figure 3.11. Pluggable Phoenix Power |
Connector for 24 and 48 Power Modules | Connector for 24P and 48P Power Modules |
RuggedCom® RuggedBackbone™ | 22 | RX1501 Installation Guide Rev 104 |
