Basic Operation

Turn on the main power switch. The POWER LED will light orange.

Press the ON button on the remote control to turn on the projector. The POWER LED flashes orange during the warm up period, then lights solid green.

LIGHT

ONOFF

VID S-VID COMP1 COMP2

RGBHD HDMI

Turning on the Power

“Searching….” appears on the screen before the projector identifies the input signal, and remains there until a valid signal is detected.

If an incompatible input signal exceeds the range of the projector a “No signal supported” message will be displayed on the screen. This message remains on the screen until you change the input signal.

Adjust the projected image size with the zoom ring on the lens. To focus the image, rotate the focus ring on the lens.

Zoom out

Focus

Zoom in

Adjusting the Zoom and Focus

To adjust the projector height or projection angle, or to compensate for a mounting surface that isn’t level, turn the four adjustable feet on the bottom of the projector.

Adjusting Projector Height or Projection Angle

Runco CL-610 Owner’s Operating Manual

27

Page 27
Image 27
Runco CL-610LT manual Basic Operation, Turning on the Power, Adjusting the Zoom and Focus