On-Screen Display Menus

Picture Quality Adjustments

Runco CL-610

>Video S-Video Component1 Component2

RGB-HD

HDMI

------------------------

Aspect Ratio

Installation Option Setup

ISF Calibration

Adjustment

Brightness

Contrast

Color

Tint

Sharpness

Filter

Color Temperature

ICC Selection

Store Image Settings

Restore Image Settings

Brightness

Contrast

Color

Tint

Sharpness

To access the picture quality adjustments, press Menu, highlight the active source and press Enter or ►. The picture quality sub-menu then appears (see above).

To adjust a setting, highlight it with the ▲ or ▼ button and press Enter to activate a scroll bar for that setting. Use the ◄ or ► keys to change the setting. When finished, press Exit.

Select Brightness to adjust the black level of the projected image (0 = minimum; 60 = maximum).

Select Contrast to adjust the white level of the projected image (0 = minimum; 32 = maximum).

Select Color to adjust the color level (saturation) of the projected image (0 = minimum; 64 = maximum).

Select Tint to adjust the hue of the projected image (0 = minimum; 30 = maximum).

Select Sharpness to adjust the sharpness of the projected image (-14 = minimum; +20 = maximum). This setting has no effect if the Sharpness Filter is set to 0 (refer to the next paragraph).

Filter The Filter setting controls the behavior of the Sharpness control. The available settings depend on the vertical resolution of the input signal, as follows:

With a 480i signal, you can apply the sharpness control to either the input signal (1), the output signal (2), both (3) or neither (0).

With a 480p or higher-resolution signal, the sharpness control is applied only to the output signal and only when you set the Sharpness filter to “on” (1).

32

Runco CL-610 Owner’s Operating Manual

Page 32
Image 32
Runco CL-610LT manual Picture Quality Adjustments, Runco CL-610