Runco CR-26HD, CR-32HDi manual Timer, Channel Auto Tuning Add/Erase Favorite Channel

Operation

Channel ➤

Channel

Auto Tuning

Add/Erase

Favorite Channel

Timer ➤

Timer

Time

On Timer

Off Timer

Sleep Timer

Time Zone

To set up the Crystal Series LCD Display channel tuner, select TV as the source. Then, select Channel from the Main Menu and press ENTER.

Auto Tuning: To have the Crystal Series LCD Display automatically detect available TV or CATV channels, select Auto Tuning and press ENTER.

•Off-Air Channels: If you are using an off-air antenna, select AIR and press ENTER again. The Crystal Series LCD Display searches all channel frequencies and adds a channel to its memory when it detects a signal on that channel frequency. (This may take a few minutes.)

•CATV Channels: If you are using cable, select CABLE and press ENTER. Then, select STD and press ENTER again. The Crystal Series LCD Display searches all channel frequencies and adds a channel to its memory when it detects a signal on that channel frequency. (This may take a few minutes.) If Auto Tuning fails to detect any CATV channels, select HRC or IRC and try again. (STD, HRC and IRC refer to different sets of frequencies used by cable television providers. IRC stands for “Incrementally Related Carrier;” HRC stands for “Harmonically Related Carrier.”)

Add/Erase: If Auto Tuning fails to detect a channel, select Add/Erase from the Channel menu, then select Add to add it to the channel list. To erase the currently-selected channel from the available channel list, select Add/Erase from the Channel menu, then select Erase.

Favorite Channel: You can specify up to four channels as “favorite” channels that can be accessed by pressing a single button on the remote, instead of manually entering the channel number. To do this, select Favorite Channel from the Channel menu and press ENTER.

Use the up- or down-arrow button to select the memory location in which you want to store the favorite channel. Then, use the left- or right-arrow button to specify the channel number.

To recall a favorite channel, press the corresponding button on the remote control (FC1, FC2, FC3 or FC4).

To set the Crystal Series LCD Display internal clock or configure the on/off timers, select Timer from the Main Menu and press ENTER.

Time: To set the Crystal Series LCD Display internal clock, select Time from the Timer menu and press ENTER. Use the up- or down-arrow button to select either the hour of the day or the minute of the hour to set. Then, use the left- or right-arrow buttons to set that component of the time. When finished, press MENU.

On Timer: Use the On Timer to turn the Crystal Series LCD Display on at a specific time of day. You can also specify a channel and a volume level.

Off Timer: Use the Off Timer to turn the Crystal Series LCD Display off at a specific time of day.

Sleep Timer: Use the Sleep Timer to turn off the Crystal Series LCD Display after a specified interval.

To set the Sleep Timer:

•Select Sleep Timer from the Timer menu and press ENTER. Use the right- or left-arrow button to select 10, 30, 60, 120 or 180 minutes. Then, press MENU.

– OR –

•Press the TIMER OFF button on the remote control repeatedly to select the desired timer interval.

34 Runco CR-26HD/CR-32HDi Owner’s Operating Manual