Runco D-73D operation manual Installing the Optional Anamorphic Lens Mount

Installation

If you are installing a standard D-73d (without an anamorphic lens), skip this step and proceed with Mounting the D-73d(page 36).

If you are installing a D-73d/CineWide, proceed with Installing the Fixed CineWide Base Plate (D-73d/CineWide)(page 34).

If you are installing a D-73d/CineWide with AutoScope, proceed as follows to install the AutoScope lens motor.

3.4

Installing the Optional Anamorphic Lens Mount

1. Do not install the CineWide lenses yet, only the fixed CineWide

Note base plate or AutoScope lens motor. You will install the CineWide lenses after you install the projector and adjust the primary lenses.

2.Some components shipped with your projector may differ slightly from what is shown in these instructions.

Your D-73d/CineWide with AutoScope may have shipped with the

Note AutoScope lens motor pre-installed. If so, proceed with

Connecting the AutoScope Lens Motor to the Projector (page 33).

Remove Projector Feet: Place the projector upside down on a blanket or other soft surface. Loosen and remove the two front feet on the projector.

Installing the CineWide/AutoScope Lens Motor (D-73d/CineWide with AutoScope)

D-73d Series Installation/Operation Manual 31