Installation
8.Focus Left (Top) Primary Lens: To focus the projected image, grasp the lens by the outer ring and rotate it.
9.Adjust Zoom on Left (Top) Primary Lens: To make the projected image smaller (zoom out) or larger (zoom in), move the zoom tab in the appropriate direction.
10.Adjust Vertical Offset on Left (Top) Primary Lens: To shift the projected image
vertically, insert the provided hex wrench into the vertical lens shift adjuster on the side of the projector. Then, turn the wrench as shown to shift the lens in the desired direction.
Focus
Zoom
Projection
Lens
Lens Lock
Horizontal
Lens Shift
Vertical
Lens Shift
11.Adjust Horizontal Offset on Left (Top) Primary Lens: To shift the projected image horizontally, insert the provided hex wrench into the horizontal lens shift adjuster at the top of the projector. Then, turn the wrench as shown to shift the lens in the desired direction.
THE LENS SHIFT MECHANISM CAN BE DAMAGED BY WARNING EXCESSIVE FORCE.
•Ensure that the lens lock is released before adjusting horizontal or vertical lens shift.
•Do not attempt to move the primary lenses beyond their normal adjustment ranges.
12.Lock Left (Top) Primary Lens Position and Zoom Settings: When you have finished adjusting the lens position and image size (zoom), insert the provided hex wrench into the lens lock access hole at the front of the projector. Then, turn the wrench clockwise two or three full turns to lock the lens position.
Right (Bottom) Primary Lens Adjustment:
1.On the DHD Controller remote control or front panel, press MENU.
2.Select Calibration from the Main Menu.
3.Select Adjustment Mode from the Calibration Menu and set it to Secondary.
4.Press EXIT (or MENU) repeatedly to return to the Main Menu.
5.Select Service from the Main Menu.
6.Select Test Video from the Service Menu and choose Secondary Alignment.
7.Perform Steps 8 through 12 above with the right (bottom) primary lens.
When you have completed the primary lens adjustments
55 |
