Runco Q-750I operation manual 2. Q-750iMain Menu, Operation

Operation

Main ➤ The Q-750i Main Menu, shown in Figure 4-2,provides access to the most commonly-used projector functions.

1. For best results, Runco recommends that you set

Note ConstantContrast to Off before adjusting Brightness, Contrast and other image quality settings in this menu (refer to ConstantContrast on page 58). After you have completed the initial calibration, set ConstantContrast to On if desired.

2.Image controls only operate on the active source. To adjust the PIP source, switch to the PIP source (thereby making it the active source), adjust the controls and then switch back.

Figure 4-2. Q-750i Main Menu

Aspect Ratio: To change the aspect ratio (size and shape) of the projected image, press or to highlight Aspect Ratio. Use the or buttons to select the appropriate aspect ratio for your screen size, installed lens configuration and the type of program material being viewed, then press ENTER; refer to Table 4-2.

46 Q-750i Series Installation/Operation Manual