Runco Q-750I 2.Serial Commands, Input op sharp.mode = 1 CR, Response OP SHARP.MODE = 1 CR

Serial Communications

Input: op sharp.mode = 1 [CR]

Response: OP SHARP.MODE = 1 [CR]

Input: op sharp.simple = 50 [CR]

Response: OP SHARP.SIMPLE = NA [CR]

Input: op sharp.simple ? [CR]

Response: OP SHARP.SIMPLE = NA [CR]

The last three commands show what happens when a control is grayed out. In this case, the sharpness mode was set to advanced (value = 1) and then the simple sharpness slider was attempted to be adjusted and queried. The response was “NA” or not available.

Table 6-2. Serial Commands

Operation Commands Values Notes

aspect	= ?	0	= 16:9
		1	= Letterbox
		2	= 4:3
		3	= VirtualWide
		4	= Cinema
		5	= VirtualCinema

memory	= ?	0	= Custom 1	? returns a value only if
		1	= Custom 2	ISF Day or ISF Night is
		2	= ISF Day	active, otherwise it returns
		3	= ISF Night	NA.
		4	= Default

save.mem	=	0	= Custom 1
		1	= Custom 2
save.isf	=	0	= ISF Day
		1	= ISF Night
bright	= ? + -	0 - 200
contrast
saturat
tint
sharp
nr
overscan	= ?	0	= Off
		1	= Crop
		2	= Zoom
source.sel	= ?	0	= HDMI 1
		1	= HDMI 2
		2	= RGB
		3	= Component 1
		4	= Component 2
		5	= S-Video
		6	= Video
		7	= SCART

Q-750i Series Installation/Operation Manual 77