Runco Q-750I operation manual Turning on the Power, Primary Lens Adjustments, Zoom, Focus

Installation

3.7

Turning on the Power

3.8

Primary Lens Adjustments

1.Turn on your source components.

2.If this is an AutoScope-equipped projector, turn on the main power switch at the rear of the AutoScope lens motor. The lens motor power switch is located next to the AC input (see above).

3.Press the ON button on the remote control to turn on the Q-750i. The LED flashes green to indicate that it is warming up.

4.When the projector is ready for use, the LED turns off.

The Q-750i gives you a great deal of control over the picture size, position and focus.

Focus and Zoom ➤ To focus the projected image, grasp the lens by the outer ring and rotate it.

To make the picture smaller (zoom out) or larger (zoom in), move the zoom tab in the appropriate direction.

Zoom	Zoom
in	out

Focus

Lens Shift ➤ To access the lens shift controls, loosen the Phillips screw at the bottom of the decorative

bezel on the front of the projector (see Figure 2-1). Then, remove the bezel.
Vertical Lens Shift: To shift the	Horizontal	Vertical
projected image vertically, insert
	Lens Shift	Lens Shift

the provided hex wrench into the vertical lens shift adjuster at the top of the projector (directly above the lens). Then, turn the wrench as shown to shift the lens in the desired direction.

Horizontal Lens Shift: To shift the projected image horizontally, insert the provided hex wrench into the

horizontal lens shift adjuster at the Lens top of the projector. Then, turn the

wrench as shown to shift the lens in the desired direction.

When you have finished adjusting the lens position, re-install the jewelry.

34 Q-750i Series Installation/Operation Manual