Runco SC-1 manual Quick Setup, Installation specialist, Step Procedure For Details, Refer to

Installation

3.2

Quick Setup

Table 3-1gives a quick overview of the SC-1 installation process. The sections following this one provide detailed instructions.

	Note		Installation should be performed by a qualified custom video
			installation specialist.
Table 3-1. Installation Overview
Step			Procedure	For Details, Refer to
				page...
1		Choose a location for the projector		19
2		Install primary projection lens, lamp and heat extractor		24
3		Install CineWide lens mounting assembly (stationary base		29
		plate or AutoScope lens motor – optional)
4		Mount the projector		31
5		Connect the DHD Controller to the projector		32
6		Connect signal sources to the DHD Controller		34
7		Connect external controller to RS-232 port (optional)		38
8		Connect AutoScope lens motor and/or other equipment to		38
		12-volt trigger outputs (optional)
9		Connect power supply/lamp ballast, if separate from		39
		projection head (split-body configuration)
10		Apply power to the projector		42, 43
11		For rear-screen installations, select the proper picture		46
		orientation
12		Primary lens adjustments: projected image size (zoom),		22, 46
		position (shift) and focus
13		Install CineWide anamorphic lens (optional)		48
14		CineWide lens adjustments: position, pitch (angle),		50
		geometry and focus
15		Calibrate projector input 1 (RGBHV): perform Auto Setup,		53
		then adjust size/position, input levels, brightness/contrast
		etc., as needed
16		Repeat Step 15 for projector Input 2 (DVI), if used		53
17		Adjust lamp output, as needed		64
18		DHD Controller input calibration: adjust the following for		69 through 76
		each DHD Controller input, starting with Component
		SD; save settings when finished:
		• Aspect ratio	• Color level
		• Brightness	• Tint
		• Contrast	• Input position

18 Runco SC-1 Owner’s Operating Manual