Runco SC-1 Cleaning the Lens Removing Dust, Cleaning the Reflector Removing Dust, Cleaning Other

Maintenance and Troubleshooting

Cleaning the Lens ➤ Removing Dust:
1.	Brush most of the dust off with a camel-hair brush and/or blow dust away with
	compressed air.
2.	Fold a microfibre cloth smooth and gently wipe remaining dust particles off the lens.
	Make sure to wipe evenly with the smooth portion of the cloth that has no folds or
	creases. Do not apply pressure with your fingers — use the tension in the folded cloth
	itself to collect the dust.
3.	If significant dust is still bound to the surface, dampen a clean microfibre cloth with
	lens cleaning solution (damp, not dripping). Wipe gently until clean.

Removing Fingerprints, Smudges, Oil and Other Substances:

1. Brush most of the dust off with a camel-hair brush and/or blow dust away with compressed air.

2. Roll a lens tissue around a swab and soak in lens cleaning solution. The tissue should be damp but not dripping.

3. Gently wipe the surface using a figure-8 motion. Repeat until blemish is removed.

Cleaning the Reflector ➤ Removing Dust:
1.	Brush most of the dust off with a camel-hair brush and/or blow dust away with
	compressed air.
2.	If some dust remains, just leave as is — air circulating at the lamp is unfiltered, so
	some dust is inevitable. Avoid unnecessary cleaning.

	Removing Fingerprints, Smudges, Oil and Other Substances:
	1.	Brush dust off with a camel-hair brush and/or blow dust away with compressed air.
	2.	Fold a clean microfibre cloth and dampen with methanol. Make sure to wipe evenly
		with the smooth portion of the cloth that has no folds or creases. Do not apply
		pressure with your fingers; use the solution in the cloth to collect the dirt.
Cleaning Other ➤	In a normal operating environment check, clean and treat the following components every
Components	six months or so to help ensure proper lamp and projector function:
	Lamp Fan: A clogged lamp fan impeller or motor can reduce air flow, leading to possible
	overheating and failure of the lamp. Clean and treat the impeller as follows:
	1.	Vacuum loose dirt from the lamp fan impeller.
	2.	If necessary, use a brush with hot water and suitable detergent.
		Do not bend the impeller blades or loosen the balancing weights.
		WARNING

Igniter: Clean the high voltage terminal and insulator to remove accumulated dust or dirt.

86 Runco SC-1 Owner’s Operating Manual