Runco manual Mounting the SC-1, Do not attempt to invert or ceiling-mount the SC-1

Installation

Mount the SC-1 on a strong supporting structure or cart. Carts can be useful when moving a projector during a presentation or from site to site. If possible, lock the wheels when it’s in position to prevent it from being moved during a presentation.

Take special care if using a mobile cart; avoid sudden stops, force and uneven surfaces that may cause the top-heavy cart to lurch and overturn. Make sure your mounting structure is reasonably level, then adjust one or more projector feet as necessary to fine-tune.

Do not attempt to invert or ceiling-mount the SC-1.

WARNING

3.6

Mounting the SC-1

For installations on a floor or suitable supporting structure, a single projection head should	Adjusting the Feet
rest firmly on its feet. To adjust the height and level of the projector, extend or retract the
feet by rotating them using a crescent wrench; see Figure 3-9.
You can tilt the front end of the projector up or down as much as 15 degrees. Likewise,	Tilting the Projector
you can tilt it side-to-side up to 15 degrees. This limit ensures safe lamp operation and
proper position of the liquid cooling reservoir in the projector. See Figure 3-12.

Figure 3-12. Tilt Ranges (Front-to-Back and Side-to-Side)

Tilt only as shown, and only if absolutely necessary.

WARNING

Runco SC-1 Owner’s Operating Manual 31