Runco SC-1 manual You must enter a passcode to access the Service menu

Installation

3.10

Selecting the Input Source

3.11

Adjusting the Picture Orientation

3.12 Primary Lens Adjustments

By default, the SC-1 is configured to display the signal received on Input 1 (RGB). To use Input 2 (DVI) instead:

1. On the DHD Controller, press MENU and enter the Service Menu passcode.

You must enter a passcode to access the Service menu.

Note

2.Select Service from the Main Menu.

3.Select Display Device from the Service Menu.

4.Press to select DVI/HDMI, then press ENTER.

By default, the SC-1 is configured for a “floor/front” installation, in which the projector is installed upright and in front of the screen. If it is installed behind the screen, you must switch to a “floor/rear” picture orientation. To do this:

1.On the DHD Controller, press MENU and enter the Service Menu passcode.

2.Select Service from the Main Menu.

3.Select Display Device from the Service Menu.

4.Select Configure from the Display Device menu, then select Installation.

5.Choose Floor/Rear.

This initial optical alignment procedure is the foundation for optimizing your displays, ensuring that images reflected from the DMDs are parallel to and well-centered with both the lens and screen.

Before you begin, properly position the projector relative to the screen (refer to Vertical and Horizontal Position on page 22).

Double-check projector leveling (refer to Adjusting the Feet on page 31) so that the top edge of the image is parallel to the top edge of the screen.

46 Runco SC-1 Owner’s Operating Manual