Maintenance and Troubleshooting | Runco VX-2i manual

Maintenance and Troubleshooting

Table 5-1. Troubleshooting Chart (continued)

Symptom	Possible Cause(s)	Solution
Colors in the image are	• The Red/Pr, Green/Y or	• Ensure that the source
swapped; for example, reds	Blue/Pb outputs from the	outputs are connected to
appear blue or vice versa.	source are connected to	the correct VX-2i input.
	the wrong inputs on the
	VX-2i.

The projector will not turn	• The projector will not turn	• Wait two minutes until the
back on after it was powered	on for two minutes after	LED at the front of the
down, or the image disap-	power-down, to protect	VX-2i turns red.
pears during operation.	the lamp.
	• The lamp has failed.

40	Runco VX-2i Owner’s Operating Manual

Image 50

Runco VX-2i manual Maintenance and Troubleshooting

Contents

VX-2i Page TWO Year Limited Warranty For Projectors, Video Processors and Controllers Effective Warranty Date Runco INTERNATIONAL, INC Safety Precautions Table of Contents Operation Maintenance and TroubleshootingSpecifications Serial Communications List of Figures List of Figures Introduction About This Manual Using This Manual If you need Turn to Description, Features and Benefits Key Features and Benefits Optional Accessories Controls and Functions VX-2i at a Glance Component Video RCA connectors HD1 / HD2 Analog BNC connectors Volt 800 mA Trigger Outputs Video 1 / S-VIDEO VX-2i Remote Control Power Input 100 to 240 VAC Connect the VX-2i to power here Video On / OFFCursor Keys Comp Component Letbox Letterbox Aspect Ratio Selection ButtonsANA Anamorphic 3 For 169 DVDs 4X3 Standard 43 Wide VirtualWide Installation Remote Control Quick Setup Step Procedure For Details, Refer to Installation Considerations Installation Type Flat vs. Curved Screens Throw Distance Ambient LightOther Considerations Throw Ratio Throw Distance Range Lens Option Note Throw Dist Screen Width Minimum Maximum Lens Shift Vertical and HorizontalPosition Vertical Lens Shift Mounting Adjusting the ProjectionAngle Folded Optics Connections to Connector Panel AccessConnecting the VX-2i to VX-2i Digital DTV RGB Connections See Figure Digital DTV RGB Connections Analog Computer RGB Connections See Figure Analog RGB Connections Composite/S-Video/Component Video Connections See Figure 10. Composite, S-Video and Component Video Connections Connection Connecting 12-VoltRS-232 Controller Trigger Outputs to Operation Turning on the PowerAdjusting the Picture Orientation Focus Zoom Shift Lens AdjustmentsUsing the On-Screen Menus Input Source ISF PresetsService Aspect Ratio Aspect Ratio Main MenuInput Source Input Source Composite Video Component SD Aspect Ratio Settings Remote Aspect Ratio Control Description Key Picture Picture Brightness Contrast Color Tint Sharpness Typical Gray Bar Pattern for Adjusting Contrast Gray Yellow Cyan Green Magenta Red Blue Input Position Input Position Left/Right Up/Down Width Height Overscan Calibration ISF PresetsInformation Should be used by ISF-certified technicians only Operation Service Tip Operation Symptom Possible Causes Solution Maintenance and TroubleshootingLamp Replacement Troubleshooting Tips Maintenance and Troubleshooting Command Parameter Value Description Min/max Stored? RS-232 Connection and Port ConfigurationSerial Command Syntax Serial Communications Serial Communications Night YES SHARPNESS? Specifications VX-2i Specifications Power Requirements Home Theater Calibration SpecificationsIndustry-Standard Specifications Dimensions Limited Warranty Specifications are subject to change without notice VX-2i Dimensions VX-2i DimensionsPage Runco CL-810 Owner’s Operating Manual