Runco VX-8D Quick Setup, 1. Installation Overview, Step, Procedure, For Details, Refer to, page

Installation

3.2

Quick Setup

Table 3-1gives a quick overview of the VX-8d installation process. The sections following this one provide detailed instructions.

Table 3-1. Installation Overview

Step	Procedure	For Details, Refer to
		page...
1	Choose a location for the projector	17
2	Install CineWide lens mounting assembly (stationary base	23
	plate or AutoScope lens motor – optional)
3	Mount the projector	28
4	Connect the DHD Controller to the projector	29
5	Connect signal sources to the DHD Controller	31
6	Connect external controller to RS-232 port (optional)	36
7	Connect 12-volt trigger outputs to AutoScope lens motor	37
	and/or other equipment (optional)
8	Connect projector, DHD Controller and lens motor (if	39
	present) to AC power and power up
9	Primary lens adjustments: projected image size (zoom),	20, 40
	position (shift) and focus
10	For rear-screen and/or ceiling-mount installations, select	40
	the proper picture orientation
11	Install CineWide anamorphic lens (optional)	41
12	CineWide lens adjustments: position, pitch (angle),	41
	geometry and focus
	Display calibration: adjust the following for each input and	49
	display mode (resolution and frame rate); save settings
	when finished:
	• Aspect ratio
13	• Brightness
	• Contrast
	• Color level
	• Tint
	• Sharpness
	• White Balance

16 Runco VX-8d Installation/Operation Manual