Controls and Functions
2.2
DHD Controller Front Panel
1.SLOT 1 Not used.
2.SLOT 2 (Dual HDMI input)
Two,
DHD Controller to input “A” in this slot.
3.SLOT 3 (COMPONENT/RGB input) Not used.
4.PC IN Not used.
5.RS-232C (9-pin, male D-Sub)
Connect the Display Control
6.POWER INPUT
Connect the PlasmaWall to AC power here.
Figure
3
HDMI 1 |
16:91080i/60
11 10 9
| ra tio | ||
standby | nt | er | |
i | |||
e | |||
n |
|
| |
p |
|
| |
u |
|
| |
t |
|
|
i n p u t
m
e n u
r
atio
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
Figure 2-5. DHD Controller Front Panel
1.RUNCO ICON
Lights blue to indicate that the controller is on or powering up.
2.IR SENSOR
Receives IR commands from the remote control.
3.VACUUM FLUORESCENT DISPLAY
Can be used instead of the
4.ON/STANDBY BUTTON
Press once to toggle from standby mode to on mode. Press it again to return to standby mode. For a discrete on or off command, you can use the direct access buttons on the remote control.
8 | PlasmaWall XP Series Installation/Operation Manual |