3. Installation
To install batteries in the remote control:
1.Press down the tab on the cover and pull the cover in the direction of the
arrow.
2. Insert the included batteries. Ensure that the polarities correctly match the and markings inside the battery compartment.
3. Insert the lower tab of the cover into the opening, and press down the cover until it clicks in place.
•When installing batteries, make sure that the battery polarities are correct.
•Do not mix an old battery with a new one or different types of batteries.
•If you will not use the remote control for a long time, remove the batteries to avoid damage from battery leakage.
The remote control can be used to control the PlasmaWall within the ranges shown in Figure
3.1
Remote Control
Notes on Batteries
Notes on Remote Control Operation
3
Approx.
30º
|
|
| ra tio |
|
|
| HDMI 1 | standby | enter | n |
|
| n |
| |||
|
| i | i | m | |
|
| p |
| p | e |
16:9 | 1080i/60 | u |
| u | n |
t |
| t | u | ||
|
|
| r atio |
|
|
Approx.
40 feet
(12.2 meters)
Approx.
30º
EXIT
|
| 16 : 9 |
|
| 4 : 3 |
HDMI | HDMI |
|
1 | 2 |
|
CUST | CUST | SVC |
1 | 2 |
Figure
PlasmaWall XP Series Installation/Operation Manual | 15 |