Russound CAM6.6T UNO-TS2Touchscreen Control, UNO-TS2Control of Tuner, Selecting the tuner, User

USER

INTERNAL SOURCE - AM/FM TUNER

UNO-TS2 Touchscreen Control

UNO-TS2 Control of Tuner	screen. These will be selected from the bank
Selecting the tuner	that is currently selected.

On the UNO-TS2 touchscreen home page, press the named source button to select the AM/FM tuner.

Selecting a Bank

From the “1 of 3” tuner screen, select the bank by scrolling using the forward/back arrow next to the bank name. The bank name shows in the window. There are six available banks that store up to six presets each. Banks and memory pre- sets are custom-named in the Peripheral Setup Menu (see Installation Menu section of this manual).

Setting a Memory Preset

From the “1 of 3” tuner screen, press the “tune” up/down hard button functions to select the desired station. Press and hold one of the six buttons in the middle of the screen to save the preset. When you hear the harp sound from the touchscreen, the preset is saved. The preset name then appears on the buttons. These may be custom names or frequencies.

New presets can be saved over existing presets using the same method.

Note: If the UNO-TS2 is powered on before the Russound Tuner is turned on, existing preset names may not appear until after the tuner’s boot up procedure is complete (less than a minute).

Recalling a Memory Preset

From the “1 of 3” tuner screen, press and hold one of the six buttons in the middle of the screen to recall the preset. Only configured pre- sets will be displayed.

Presets can also be recalled from any tuner screen by using the “memory up/down” hard button functions on the bottom right of the

Selecting the desired band

From the “2 of 3” tuner screen, press the “AM” or “FM” button to select the desired band.

Selecting the desired frequency

From the “2 of 3” tuner screen, enter the 3- or 4-digit frequency number. The “tune up/down” hard buttons can also be used to select a sta- tion.

Frequency Seek and Scan

From the “3 of 3” tuner screen, select either the “Seek” or “Scan “ button. Press the button to begin the seek or scan function, then press the “Stop” button on the screen to end. The “tune up/down” hard buttons can also be used to select a station.

Local - Distant Reception

From the “3 of 3” tuner screen, the Local/Distant Reception setting changes how the tuner’s antenna picks up signals. Normal operation is in Distant mode.However, in cities, antennas can pick up multipath signals when they bounce off buildings and get doubled. In these cases, the Local mode limits the noise associated with these reflected signals.

Stereo - Mono Output

From the “3 of 3” tuner screen, change the out- put of a radio station by choosing either Stereo or Mono.

Mute

Press the mute hard button on the outside left of the UNO-TS2 to mute the tuner when it is the selected source.

20