INSTALLER
WIRING INSTRUCTIONS
Wire Length
To determine the amount of
•Make sure that the entire wire path between keypads and CAM6.6 is clear and not obstructed by a floor ceiling joist, or masonry wall which can’t be drilled through.
•Confirm ahead of time that you can drill an outlet hole easily and in an unobtrusive spot to connect wires with the CAM6.6.
•Label wires with keypad and room location. This simplifies CAM6.6
RJ-45 Connections
The
Speaker Wiring
Standard
When running wire, pay particular attention to the following areas:
•Avoid locations concealing pipes, heating ducts and AC wiring in the general vicinity.
•Avoid running wires close to house electri- cal wiring for any distance. If you have to run them parallel, make sure to space the wires at least two feet from the AC line.
Keypad Wiring
For the UNO keypad or touchscreen, the follow- ing connections are used to terminate the
| TYPE |
Brown . . . . . . . . . . . . . . . . . . . +12V
Brown/White . . . . . . . . . . . . . . +12V
Green . . . . . . . . . . . . . . . . . . Ground
Green/White . . . . . . . . . . . . Status In
Orange . . . . . . . . . . . . . . . . . Ground
Orange/White . . . . . . . . . . . . . IR Out
Blue . . . . . . . . . . . . . . . . . . . COM A
Blue/White . . . . . . . . . . . . . . COM B
CAT-5 110 Punchdown Connection
The UNO keypad
Caution
Take care when using an impact 110 punchdown tool, as this may overspread the contact points. Use of the impact tool may propel stray bits of wire and jacket into the keypad’s chassis and possibly cause a short in the circuitry. Gently shake or blow air through the keypad chassis to remove stray wire before the keypad is installed into the junction box.
30