INSTALLER
MAKING CONNECTIONS
Source Audio and IR Input Connections
Source Audio Connections
The CAM6.6 supports up to six audio sources. The Source Inputs are located at the back panel. For the CAM6.6 (no internal source installed), the switch next to Source 1 input must be set to “Input.” Connect each source output using quality RCA signal cables. Connect the Left and Right Audio outputs from each source to the correspon- ding inputs on the CAM6.6 controller. Label each cable with the name of the selected source and the Source Audio input number located on the CAM6.6.
For the CAM6.6T, the Source 1 input serves a dual purpose. If the CAM6.6 optional internal source is used, the Source 1 input is not avail- able, and the switch next to it is set to “Internal Source Output.” If you want to utilize the Source
1 inputs, set the switch to “Input” and reconfigure Source 1 in the Source Setup menu.
Note for CAM6.6T: If you hear more than one source when Source 1 is selected, recheck Source 1 wiring and switch setting.
Source IR Connections
Each source component has a designated IR port on the back of the CAM6.6. This IR port is directly above the Source Audio Input Connections.
1.Using an IR emitter (the Russound 845.1 is recommended) attach the end of the emitter with the 1/8” plug to the IR emitter port above the source input.
2.Remove the adhesive back at the other end of the emitter and attach the emitter over the source component’s IR window.
3.In order to control this source component with IR, the source must be selected at the keypad receiving the command.
CAM6.6
Use the Source 1 out- put/input switch for audio OUT of the internal source or audio IN of connected source equipment.
CD Changer
Tape Player
CAM6.6T with Optional Internal Source - AM/FM Tuner
34
