Russound K2 Learn IR Procedure (continued), LEARN IR, Delete IR, Learned IR, LEARNED SRC, LEARNED SRC, KEY FUNCTION, See Learn IR Procedure flow chart on page

INSTALLER

Programming Menu Instructions

Learn IR Procedure (continued)

These locations are called Learned Sources. Learned commands can be assigned in other procedures by selecting Learned IR as a command type and then selecting the corresponding Learned Source label.

See Learn IR Procedure flow chart on page 45.

To begin the Learn IR Procedure, select LEARN IR from the top level of the Programming Menu and press Play .

Note: When teaching commands, you must aim the remote at the keypad’s IR learning receiver diode. The keypad cannot learn commands through its normal IR receiver. See the diagram at right.

1.LEARNED SRC – Select and enter the Learned Source location where you want to store the commands. Usually the Learned Source label should match the source number or amp/receiver to avoid confusion. To store commands for a separate device such as a lighting system or a motorized screen, choose any unused Learned Source location.

2.KEY FUNCTION – Select and enter a function to be learned or deleted.

3.LEARN/DELETE – Select Learn IR Now or Delete IR.

a.Select and enter Learn IR Now to teach the keypad an IR command. A USE REMOTE prompt appears and a red LED on the keypad’s side flashes when ready to receive the IR signal. Hold the remote control 1 to 6 inches from the keypad. Aim the remote at the IR learning receiv- er diode on the right front edge of the keypad and quickly press and release the key for the function you want the keypad to learn.

b.Select and enter Delete IR to delete any existing command for that function. Procedure returns to LEARNED SRC (step 1).

IR learning receiver diode

Normal IR receiver

26