OIL AND FUEL INFORMATION

Using Fuel Additives

The use of fuel additives, such as STA-BIL®Gas Stabilizer or an equivalent, will inhibit corrosion and minimize the formation of gum deposits. Using a fuel additive can keep fuel from forming harmful deposits in the carburetor for up to six (6) months. Add 0.8 oz.

(23 ml.) of fuel additive per gallon of fuel according to the instructions on the container. NEVER add fuel additives directly to the unit's gas tank.

FUELING UNIT

WARNING: Gasoline is extremely flammable and its vapors can explode if ignited. To avoid serious personal injury, always stop the engine and allow it to cool before filling the fuel tank. Do not smoke while filling the tank. Keep sparks and open flames away from the area.

1.Remove fuel cap (Fig. 9). Remove the tag from the fuel tank neck.

NOTE: Fill or add fuel to the tank only when the cultivator is in a horizontal position (Fig. 9).

WARNING: Remove fuel cap slowly to avoid injury from gasoline spray.

2.Place spout of gas container into the fill hole on the fuel tank and fill tank.

Fuel Cap

Fig. 9

WARNING: Add gasoline in a clean, well ventilated outdoor area. Avoid creating a source of ignition for spilt fuel.

NOTE: Do not overfill tank.

3.Wipe up any gasoline that may have spilled.

4.Reinstall the fuel cap.

WARNING: Never operate the unit without the fuel cap securely in place.

5.Move the unit at least 30 ft. (9.1 m) from the fueling source and site before starting the engine.

NOTE: Dispose of the old gasoline in accordance to

Federal, State and Local regulations.

STARTING/STOPPING INSTRUCTIONS
STARTING INSTRUCTIONSCold Start: First Start of the Day or Engine Out of Fuel

WARNING: Operate this unit only in a well ventilated outdoors area. Carbon monoxide exhaust fumes can be lethal in a confined area.

WARNING: Avoid accidental starting. Be in the starting position whenever pulling the starting rope. To avoid serious personal injury, the operator and unit must be in a stable position while starting.

1.Check oil level in crankcase. Refer to Checking the Oil Level.

2.Fill the fuel tank with fresh, clean, unleaded gasoline.

3.Put the Start/Stop Control in the START [I] position (Fig. 10).

STOP (O)

START (I)

Throttle Control

 

Start / Stop Control

Fig. 10

4.Place the choke lever in the FULL choke (A) position (Fig. 11).

NOTE: Slide the choke lever directly above the appropriate symbol on air filter cover decal (Fig. 11).

10