Guided Tour - VR3TD Rear Panel
1
2
3
4
ENGLISH
AC CABLE LOCK
DC INPUT | UNBALANCED OUTPUT |
+ -
CAUTION
USE SAMSON
AC ADAPTER
ONLY
CABLE LOCK LOOP THRU AND TIE
S.No. CH :
Diversity Receiver
F:
BALANCED SWITCH | BALANCED OUTPUT |
LINE:
XLR:
MIC LINE①GND ②HOT ③COLD
POWER RATING
DC 12V, 1.9W(160mA)
1:DC input - Connect the supplied 12 volt 250 mA power adapter here, using the strain relief as shown in the illustration below. WARNING: The substitution of any other kind of power adapter can cause severe damage to the VR3TD and will void your warranty.
-
Using the strain relief: Gather up a loop of wire and pass it through the strain relief, then pass the adapter plug through the loop in order to create a knot.
2:Unbalanced output* - Use this unbalanced high impedance (5K Ohm) 1/4" jack when connecting the VR3TD to consumer
3:Audio Output Level switch - Sets the audio output level attenuation of the balanced output (see #4 below) to
4:Balanced output* - Use this electronically balanced low impedance (600 Ohm) XLR jack when connecting the VR3TD to professional (+4) audio equipment. Pin wiring is as follows: Pin 1 ground (shield), Pin 2 high (hot), and Pin 3 low (cold).
* If required, both the unbalanced and balanced outputs can be used simultaneously.
6