Samson VHF TD Series Guided Tour - VR3 Rear Panel, English, S.No. CH Non-DiversityReceiver F

Guided Tour - VR3 Rear Panel

1

2

3

4

ENGLISH

AC CABLE LOCK

DC INPUT UNBALANCED OUTPUT

+ -

CAUTION

USE SAMSON

AC ADAPTER -10 dB 5KΩ

ONLY

CABLE LOCK LOOP THRU AND TIE

S.No. CH :

Non-Diversity Receiver

F:

BALANCED SWITCH BALANCED OUTPUT

LINE:

-20dBm600ΩMIC:

-40dBm600Ω

XLR:

MIC LINE①GND ②HOT ③COLD

POWER RATING

DC 12V, 1.9W(160mA)

1:DC input - Connect the supplied 12 volt 250 mA power adapter here, using the strain relief as shown in the illustration below. WARNING: The substitution of any other kind of power adapter can cause severe damage to the VR3 and will void your warranty.

-

Using the strain relief: Gather up a loop of wire and pass it through the strain relief, then pass the adapter plug through the loop in order to create a knot.

2:Unbalanced output* - Use this unbalanced high impedance (5K Ohm) 1/4" jack when connecting the VR3 to consumer (-10) audio equipment. Wiring is as follows: tip hot, sleeve ground.

3:Audio Output Level switch - Sets the audio output level attenuation of the balanced output (see #4 below) to -20 dBm (line level) or -40 dBm (mic level). See the“Setting Up and Using Your VHF TD Series / VHF Series System” section on page 10 in this manual for more information.

4:Balanced output* - Use this electronically balanced low impedance (600 Ohm) XLR jack when connecting the VR3 to professional (+4) audio equipment. Pin wiring is as follows: Pin 1 ground (shield), Pin 2 high (hot), and Pin 3 low (cold).

* If required, both the unbalanced and balanced outputs can be used simultaneously.

8