Samson VHF Series, VHF TD Series owner manual Guided Tour - VH3, English

Guided Tour - VH3

x

x

x

xx

x

x

T

x

C

Z

AUDIO

B

N

A

A

3

:

1

D

H

OFF

ON

A

X

V

X

R

X

C

LOW MID

HIGH

C

X

D

BATTERY LEVEL

X

X

X

I

C

Ch2

X

F

X

C

2

1:Audio on-off switch - When set to the “on” position, audio signal is transmitted. When set to the “off” position, the audio signal is muted. Because the carrier signal remains during muting, no “pop” or “thud” will be heard. Note that turning this off does not turn off the transmitter power— it is simply a way to temporarily mute the transmission of audio signal. If you don’t plan on using the VH3 for extended periods, turn off its power by using the power on-off switch (see #3 below).

2:Battery level meter - This set of three multicolor LEDs indicates relative battery power, indicating whether the installed battery is at low (red), mid (yellow) or high (green) strength.

One or more of these will light whenever the VH3 is powered on (see #3 below). When all three are lit, the battery is at maximum strength. When only the red “low” indicator lights, RF performance is degraded and the battery needs to be replaced.

3:Power on-off switch* - Use this to turn the VH3 on or off (to conserve battery power, be sure

to leave it off when not in use).

3

SAMSON

		5
ON
	MIN MAX
OFF		4
POWER	LEVEL

ENGLISH

4:Gain control (trimpot) - This input sensitivity

control has been factory preset to provide optimum level for the particular microphone capsule provided with your VHF TD Series or

VHF Series system and so we recommend that this not be adjusted manually. If neces- sary, however, you can use the supplied plastic screwdriver to raise or lower the input level. See the “Setting Up and Using Your VHF TD Series / VHF Series System” section on page 10 in this manual for more information.

5:Battery holder - Insert a standard 9-volt alkaline battery here, being sure to observe the plus and minus polarity markings shown. We recommend the Duracell MN 1604 type battery. Although rechargeable Ni-Cad batteries can be used, they do not supply adequate current for more than four hours. WARNING: Do not insert the battery backwards; doing so can cause severe damage to the VH3 and will void your warranty.

*Be sure to mute the audio signal at your external mixer or amplifier before turning transmitter power on or off, or an audible pop may result.

11