Samson VHF Series, VHF TD Series owner manual Guided Tour - VR3 Front Panel, English

Models: VHF Series VHF TD Series

1 54
Download 54 pages 36.3 Kb
Page 7
Image 7
Guided Tour - VR3 Front Panel

Guided Tour - VR3 Front Panel

1

 

3

 

4

 

6

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

POWER

 

TX

 

10%

25%

75%

100%

125%

 

 

 

 

 

 

OFF

 

 

 

 

VR3 VHF FM RECEIVER

SAMSON

Series

VOLUME

SQL .

MIN .

M A X .

ON

ENGLISH

2

5

7

1:Antenna - The antenna mounting allows full rotation for optimum placement. In normal operation, the antenna should be placed in a vertical position. It also can be folded inward for convenience when transporting the VR3. See the “Setting Up and Using Your VHF TD Series / VHF Series System” section on page 10 in this manual for more information about antenna positioning.

2:Volume control - This knob sets the level of the audio signal being output through both the balanced and unbalanced output jacks on the rear panel. Reference level is obtained when the knob is turned fully clockwise.

3:“TX ON” LED - Lights when carrier signal of sufficient strength is being received by the VR3.

4:SQL (Squelch) control - This control determines the maximum range of the VR3 before audio signal dropout. Although it can be adjusted using the supplied plastic screwdriver, it should normally be left at its factory setting. See the “Setting Up and Using Your VHF TD Series / VHF Series System” section on page 10 in this manual for more information.

5:AF Level meter - This “ladder” display (similar to the VU bar meter used on audio devices) indicates the strength of the incoming audio signal. When the “100%” segment is lit, the incoming signal is optimized at unity gain; when the “125%” segment is lit, the signal is overloading. When only the left-most “10%” segment is lit, the incoming signal is at just 10% of optimum strength. If no segments are lit, little or no signal is being received.

See the “Setting Up and Using Your VHF TD Series / VHF Series System” section on page 10 in this manual for more information.

6:Power LED - This lights green whenever the VR3 is turned on.

7:Power switch - Use this to turn the VR3 power on and off. When it is on, the Power LED (see #6 above) is lit.

7

Page 7
Image 7
Samson VHF Series, VHF TD Series owner manual Guided Tour - VR3 Front Panel, English