Setting up Your Monitor
Plug and Play
Our adoption of the new VESA® Plug and Play solution eliminates complicated and time consuming setup. It allows you to install your monitor in a Plug and Play compatible system without the usual hassles and confusion. Your PC system can easily identify and configure itself for use with your display. This monitor automatically tells the PC system its Extended Display Identification (EDID) data using Display Data Channel (DDC) protocols so the PC system can automatically configure itself to use the flat panel display. If your PC system needs a video driver, following the instructions given below according to the operating system your computer uses.
Installing the Video Driver
When prompted by the operating system for the monitor driver, insert the Driver diskette included with this monitor. Driver installation is slightly different from one operating system to another. Follow the directions as appropriate for the operating system you have.
Windows® 2000 and Windows® 98
1 | Windows® 2000 and Windows® 98 will |
“Add New Hardware Wizard” if the drivers are not already installed. Click the | |
| NEXT button to search for drivers. |
2 | Check the diskette drive box to install the drivers off the diskette provided with your |
monitor and click NEXT. | |
3 | Confirm that Windows found the driver on the diskette and click NEXT again to install |
the driver. |
To manually install or update the driver, follow the directions below:
1 | Click on START, SETTINGS, CONTROL PANEL, DISPLAY SETTINGS tab, |
ADVANCED, MONITOR tab, CHANGE. This will start the “ Add New Hardware | |
| Wizard”. |
2 | Follow the same directions as given in the steps in the section above. |
English
5
