5cm 
less
Keep a clearance of at least
5 cm between the end of the drain hose and the ground.
Ditch
Do not place the end of the drain hose in a hollow.
After completing the installation of the drain hose, pour water into the drain pan to check whether the hose is well drained.
1) Correct connection | 2) Incorrect connection |
Drain hose | Pipe | Drain hose | Pipe |
• Don’t tie drain hose to the assembly pipe which may lead to water leakage.
• If the diameter of the connection hose is smaller than the product's drain hose, water leakage may occur.
Drain hose installation
1.If necessary, connect the 2 meter extension drain hose to the drain hose.
2.If you use the extension drain hose, insulate the inside of the extension drain hose with a shield.
3.Fit the drain hose into 1 of 2 drain hose holes, then fix the end of the drain hose tightly with a clamp.
• If you do not use the other drain hose hole, |
|
block it with a rubber stopper. |
|
4. When extending the Drain Hose, hold the end of Drain Hose and Extended Hose, |
|
rotate and insert the drain hose into Extended hose for 40~45 mm Make sure |
|
the two hoses are firmly connected, there is no water leakage. | Drain hose hole |
|
5.Connect the Drain Hose after using Foam Insulation to wrap the Extended Hose. Then, Use vinyl tape to wrap the each side of connection by 20 mm .
|
|
| 40~45 mm | 20 mm | 20 mm |
|
|
| or more | or more | |
Drain hose | Extension |
| Extension |
|
|
| drain hose | Drain hose |
|
| |
|
| drain hose | Vinyl Tape | Foam Insulation | |
|
|
|
|
|
| 2/17/2015 2:14:19 PM | |
|
| ||
|
|
|
|