Samsung BN68-02426A-00 user manual Input cables Not supplied, Problem, Possible Solution, → EnterE

Problem	Possible Solution
	••	Plasma TVs typically make a soft humming sound. This is normal. It’s caused by the
		electrical charges that are used to create the images on the screen.
	••	If the humming sound is loud, you may have set the brightness on the TV too high.
Plasma TV is making humming noise.		Try setting the brightness lower.
	••	You can also have loud humming if the back of your Plasma TV is too close to a wall
		or other hard surface. Also try rerouting your connection cables.
	••	Improper installation of wall mount can create excessive noise.
Image Retention (Burn In) Issue.	••	To minimize the possibility of screen burn, this unit is equipped with screen burn
		reduction technology. Pixel Shift technology enables you to set picture movement up/
		down (Vertical Line) and side to side (Horizontal Dot).
Can not control TV power or volume	••	Program the Cable/Sat remote control to operate the TV.
with Cable/Sat box remote control.		Refer to Cable/Sat user manual for SAMSUNG TV code.
“Not Supported Mode” message.	••	Check the supported resolution of the TV and adjust the external device's output
		resolution accordingly. Refer to resolution settings in this manual.
	•• Caption can not be selected in the TV menu when connected via HDMI or
Caption on TV menu is greyed out.		Component.
	••	Caption must be activated on the external device.
Plastic smell from TV.	••	This smell is normal and will dissipate over time.
TV Signal Strength is unavailable in the	••	This function is only available with digital channels with an Antenna (RF/Coax)
Self Diagnostic Test menu.		connection (Air or Cable).
TV is tilted to right or left side.	•• Remove the stand base from TV and reassemble.
Can not assemble stand base.	••	Make sure TV is placed on flat surface.
		If can not remove screws from TV, please use magnetized screw driver.
Channel menu is grey out (unavailable).	••	Channel menu is only available when TV source is selected (Antenna or Cable).
	••	If TV is in the Store Demo mode, it will reset audio and picture settings every
Your settings are lost after 30 minutes		30 minutes.
		Please change from Store Demo mode to Home Use mode in the Plug & Play
or every time TV is turned off.		procedure.
		Press the SOURCE button to select TV mode, go to Menu → Setup → Plug & Play
		→ EnterE
	••	Check cable connections and reconnect.
Intermittent loss of audio or video.	••	Can be caused by using overly rigid or thick cables.
		Make sure the cables are flexible enough for long term use.
		If wall mounting, we recommend using cables with 90 degree connectors.
You may see small particles if you
look closely at the edge of the bezel	••	This is part of the product’s design and is not a defect.
surrounding the TV screen.

Input cables (Not supplied)

HDMI HDMI/DVI Component Composite (AV) Coaxial (RF)

English - 36