• Wrap the cuff around the arm (refer to previous page)
•Sit upright in a chair with feet flat on the floor.
• Press " " or " " button to select a particular memory zone then press the "START/STOP" button to start the measurement. The monitor will automatically inflate to the level that is right for you.
•When taking repeat measurements, make sure to select the same memory zone before pressing "START/STOP", so the measurement is registered to the appropriate memory.
• If the result of your Systolic or Diastolic rate of your reading 
result is greater than (not equal to) your set personalized 
level the DIGIT will flash. In addition the measurement that 
is out of range, either Systolic or Diastolic, will flash. If both 
are out of range both will flash.
If the result of your Systolic or Diastolic rate of your reading result is equal or less than your set personalized level a SMILING symbol will show out and flash on screen.
The appearance of this symbol,
, signifies that a certain pulse irregularity was detected during the measurement. Talking, moving, shaking or an irregular pulse during the measurement can result in the appearance of this icon. Usually this is not a cause for concern, however if the symbol appears offen, we recommend you seek medical advice. The device does not replace a cardiac examination, but serves to detect pulse irregularities at an early stage.
• To stop a reading in process, press the "START/STOP" button.
• Press and hold "Mode" button to check the
Taking a Blood Pressure Measurement | 19 |