Samsung CLP-660 Series Supported operating systems, Configuring network protocol via the machine

Supported operating systems

The following table shows the network environments supported by the machine:

Item	Requirements
Network interface	10/100 Base-TX
Network operating	Windows 2000/XP/2003/Vista
system	Various Linux OS
	Macintosh 10.3 ~ 10.5 (CLP-610 series)
	Macintosh 10.1 ~ 10.5 (CLP-660 series)
Network protocols	TCP/IP
Dynamic addressing	DHCP, BOOTP
server

Configuring network protocol via the machine

You can set up TCP/IP Network parameters, follow the steps listed below.

Note

If you want to setup DHCP network protocol, go to the http:// developer.apple.com/networking/bonjour/download/, select the program Bonjour for Windows due to your computer operating system, and install the program. This program will allow you to fix the network parameter automatically. Follow the instruction in the installation window. This program does not support Linux.

1Make sure your machine is connected to the network with an RJ-45 Ethernet cable.

2Make sure you have turned on the machine.

3Press Menu on the control panel, until you see Network on the bottom line of the display.

4Press OK to access the menu.

5Press the left/right arrow until TCP/IP displays.

6Press OK.

7Press the left/right arrow until Static displays.

8Press OK.

9Press the left/right arrow until IP Address displays.

10Press OK.

11Enter IP address.

a.Press the left/right arrow to enter a number between 0 and 255. b.Press OK.

c.Repeat these steps to complete the address.

12Press Back to go to the upper level.

13Press the left/right arrow until Subnet Mask displays.

14Press OK.

15Enter Subnet Mask.

a.Press the left/right arrow to enter a number between 0 and 255. b.Press OK.

c.Repeat these steps to complete Subnet Mask.

16Press Back to go to the upper level.

17Press the left/right arrow until Gateway displays.

18Press OK.

19Enter Gateway.

a.Press the left/right arrow to enter a number between 0 and 255. b.Press OK.

c.Repeat these steps to complete Gateway.

Note

Contact the network administrator if you are not sure how to configure.

Note

You can also set up the network settings through the network administration programs. Refer to the user’s guide on the Network Utilities CD that came with your machine.

•SyncThru™ Web Admin Service: Web-based printer management solution for network administrators. SyncThru™ Web Admin Service provides you with an efficient way of manageing network devices and lets you remotely monitor and troubleshoot network machines from any sith with corporate internet access. Download this program from

http://solution.samsungprinter.com.

•SyncThru™ Web Service: Web server embedded on your network print server, which allows you to:

-Configure the network parameters necessary for the machine to connect to various network environments.

-Customize machine settings.

•SetIP: Utility program allowing you to select a network interface and manually configure the IP addresses for use with the TCP/ IP protocol. See Using SetIP program on page 3.5.

3.2 <Getting Started>