Samsung LH025ISFNAS/ZA manual IR sensor is not functioning

Other issue

The IR sensor is not functioning.

Make sure the sensor light turns on when a button is pressed on the remote control.

•• If the light does not turn on, turn the power switch off and then on again.

If the sensor light still does not turn on after the power switch is turned off and then on again, an internal jack may be disconnected.

Contact your nearest service center to have the product serviced.

In power-saving mode, when the input source is DisplayPort, PC display settings cannot be saved.

Go to System → General and set Max. Power Saving to Off. Alternatively, configure the PC display output settings again. Ensure the set is turned on.

When booting the PC with the input source set to	Boot the PC when the set is turned on or when the input source is not DisplayPort.
DisplayPort, the BIOS and booting screens do not appear.

87