Samsung LN52A650A1F user manual Network Settings and InfoLink, Network Connection Cable

Network Settings and InfoLink

To access Samsung’s Infolink network feature, you must make one of the connections on the following pages.

Network Connection - Cable

LAN Connection for a DHCP Environment

The procedures to set up the network using Dynamic Host Configuration Protocol (DHCP) are described below. Since an IP address, subnet mask, gateway, and DNS are automatically allocated when DHCP is selected, you do not have to enter them manually.

		TV Rear Panel
The Modem Port
on the Wall	External Modem
	(ADSL/VDSL/Cable TV)	LAN
	1
		Cable
2	Modem Cable

1.Connect the

[LAN] port on the rear panel of the TV and the external modem with a LAN Cable.

2.Connect the LAN port on the wall and the external modem with a

Modem Cable.

You can connect the LAN via a Sharer (Router).

IP Sharer TV Rear Panel

The Modem Port		LAN Cable
on the Wall
		LAN Cable
	External Modem
	(ADSL/VDSL/Cable TV)	Modem Cable

You can connect the LAN port and the TV directly depending on your network status.

TV Rear Panel

The LAN Port on the Wall

LAN Cable

➣The terminals (the position of the port and the type) of the external device may differ depending on the manufacturer.

➣If the IP address allocation by the DHCP server has failed, turn the external modem off, turn it on again after at least 10 seconds and then try again.

➣For the connections between the external modem and the Sharer (Router), refer to the owner’s manual of the corresponding product.

➣You can connect the TV to the LAN directly without connecting it through a Sharer (Router)

➣You cannot use a manual-connection-type ADSL modem because it does not support DHCP. You have to use an automatic-connection-type ADSL modem.

English - 82