OP E R AT I O N
Memorizing the Channels
Your TV can memorize and store all of the available channels for both 
and CH 
buttons to scan through the channels. This eliminates the need to change channels by entering the channel digits. There are three steps for memorizing channels: selecting a broadcast source, memorizing the channels (automatic) and adding and deleting channels (manual).
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the type of signal source that is connected to the TV (i.e., an antenna or a cable system).
1
Press the MENU button to display the menu.
Press the UP/DOWN 
buttons to select “Channel”, then press the ENTER 
button.
2
Press the ENTER 
button.
Repeatedly press the
UP/DOWN 
buttons to cycle through these choices: “Air”, “STD”, “HRC” or “IRC” (all cable TV).
Press the EXIT button to exit. 
Note : STD, HRC and IRC identify various types of cable TV systems. Contact your local cable company to identify the type of cable system that exists in your particular area.
At this point the signal source has been selected.
Proceed to “Storing Channels in Memory” (next page).
