Wireless network setup 36
2. Using a network-connected machine
►Connecting in PIN mode
1The network configuration report, including PIN, must be
printed.
In ready mode, press and hold the (Cancel or Stop/Clear)
button on the control panel for about 5 seconds. You can find
your machine’s PIN number.
2 Press and hold the (WPS) button on the control panel for
more than 4 seconds until the status LED stays on.
The machine starts connecting to the access point (or wireless
router).
3 You need to enter the eight-digit PIN within two minutes in
order to link the computer that is connected to the access
point (or wireless router).
The LED blinks slowly for up to two minutes until you enter the
eight-digit PIN.
The WPS LED blinks in the order below:
a The light blinks fast on the WPS LED. The machine is
connecting to the access point (or wireless router).
b When the machine is successfully connected to the
wireless network, the WPS LED light stays on.
Re-connecting to a network
When the wireless function is off, the machine automatically tries to
re-connect to the access point (or wireless router) with the
previously used wireless connection settings and address.
In the following cases, the machine automatically re-
connects to the wireless network:
• The machine is turned off and on again.
• The access point (or wireless router) is turned off and on
again.
Canceling the connection process
To cancel the wireless network connection when the machine is
connecting to the wireless network, press and release the (Cancel
or Stop/Clear) button on the control panel. You need to wait 2
minuites to re-connect to the wireless network.