FLOORING
For proper installation, you must place this refrigerator on a level, hard surface that is the same height as the rest of the fl oor. This surface should be strong enough to support a fully loaded refrigerator, or approximately 286.6 lbs (130 kg).
To protect the fi nish of the fl ooring, cut a large section of the cardboard carton and place it under the refrigerator where you are working. When moving the refrigerator, you need to pull and push it straight forwards or back. Do not wiggle it from side to side.
ACCESSORIES AND REQUIRED TOOLS
The following accessories are included with your refrigerator:
REMOVING THE REFRIGERATOR DOORS
Before removing the door/drawer, make sure you read the following items:
Disconnect power to the refrigerator before WARNINGremoving the door or drawer.
• Be careful not to drop, damage or scratch the door/drawer while removing them.
•Be careful not to get injured while removing the door/drawer.
•Reattach the door/drawer properly to avoid:
-Moisture from air leakage.
-Uneven door alignment.
-Wasting energy due to improper door seal.
Disassembling the fridge door
Be careful not to drop and scratch the WARNING doors while removing the doors.
1.Remove the 3 screws holding down the top table and remove it.
01 SETTING UP
Top Table
Hex wrench
Required Tools (Not provided)
You need the following tools to complete the installation of your refrigerator:
Philips | Socket wrench | |
screwdriver(+) | (10 mm) | |
Pliers | Allen wrench |
|
(3/16”) (5 mm) |
| |
|
|
2.Disconnect electric wire on the top of the refrigerator.
setting up _11
2012.7.3 10:53:27 AM |
