Samsung RF28HFEDBSR/ML manual Ice Making, If There is a Power Failure, Using the ice off Function

Ice Making

To fill the ice bucket to maximum capacity after installation, follow these steps:

1.Allow your refrigerator to operate and cool down for 24 hours (or 1 full day).

-- Waiting 24 hours will allow your ice maker to cool properly.

2.Dispense 4 to 6 ice cubes into a glass.

3.After 8, and then 16 hours, dispense a full glass of ice.

•To clean the ice bin/bucket, wash with a CAUTION mild detergent, rinse well, and then dry it

thoroughly.

Do not use harsh or abrasive cleaners or solvents.

• When you select Cubed Ice after using the Crushed Ice mode, a small amount of residual crushed ice might be produced.

If There is a Power Failure

If a power failure occurs, ice cubes may melt, and then freeze together when the power comes back on, preventing the dispenser from working properly.

To prevent this problem, after a power failure, pull out the ice bucket and discard the residual ice or water.

After you dump the ice from the ice bucket, you should press the dispenser lever once with the ‘Water’ or ‘Ice Type’ function ON.

The ice maker will make new ice faster after you return the ice bucket to the refrigerator.

If you use all the ice at once, you must repeat Steps 2 and 3 under Ice Making. However, only wait 8 hours before dispensing the first 4 to 6 ice cubes. This will replenish the ice cubes and ensure maximum ice production.

Using the ice off Function

When you select the Ice Off mode, remove all ice cubes from the bucket.

If you leave the ice cubes in the bucket, the ice cubes may clump together, making it difficult to remove them.

To remove the ice bucket safely and avoid injury, hold the bottom of the bucket with one hand and the side of the bucket with the other.

Then, lift up on the ice bucket, and pull it straight out.

To put the ice bucket back in, push it firmly straight back.

If the ice bucket is not pushed firmly into place, ice in the bucket can melt.

If the bucket does not fit, turn the helix 90 degree (see the last illustration on the right, below) and try again.

•Use only the ice maker provided with the CAUTION refrigerator.

The water supply to this refrigerator must only be installed/connected by a suitably qualified person.

Connect to a potable water supply only.

•To operate the ice maker properly, water pressure of 20 ~ 125 psi is required.

English - 32

DA68-02953B-01.indb 32 2016. 12. 16.

�� 11:05