Samsung RF28HFEDBSR/ML Removing the Refrigerator Doors, Flooring, When moving your refrigerator

When moving your refrigerator

To prevent floor damage, be sure the front CAUTION adjusting legs are in the up position (above

the floor).

Refer to “Leveling the Refrigerator” on page 21.

Flat-blade screw	Control Lever
driver (-)

REMOVING THE REFRIGERATOR DOORS

For some installations, you need to remove the fridge and freezer drawers so you can move the refrigerator to its final location.

Do not remove the doors/drawer if you don’t need to.

If you do not need to remove the refrigerator doors, go to “Leveling the Refrigerator” on page 21.

If you need to remove the doors. continue below. Before removing the door/drawer, make sure you read the following items:

Disconnect power to the refrigerator WARNING before removing the door or drawer.

Flooring

For proper installation, you must place this refrigerator on a level, hard surface that is the same height as the rest of the floor.

This surface should be strong enough to support a fully loaded refrigerator.

To protect the finish of the flooring, cut a large section of the cardboard carton and place it under the refrigerator where you are working.

When moving the refrigerator, you need to pull and push it straight forwards or back.

Do not wiggle it from side to side.

•Be careful not to drop, damage or scratch the door / drawer while removing them.

•Be careful not to injure yourself while removing the doors / drawer.

•Reattach the door/drawer properly to avoid:

-- Moisture from air leakage. -- Uneven door alignment.

-- Wasting energy due to improper door seal.

Disassembling the refrigerator doors

Be careful not to drop and scratch the WARNING doors while removing them.

English - 18

DA68-02953B-01.indb 18 2016. 12. 16.

�� 11:05