When moving your refrigerator
To prevent floor damage, be sure the front CAUTION adjusting legs are in the up position (above
the floor). Refer to ‘Adjusting the Level’ in the manual (on page 13).
Required Tools (Not provided)
You need the following tools to complete the installation of your refrigerator:
Philips | Socket wrench | |
screwdriver(+) | (10mm) | |
Pliers | Allen wrench |
|
(3/16”) (5mm) |
| |
|
|
FLOORING
For proper installation, you must place this refrigerator on a level, hard surface that is the same height as the rest of the fl oor. This surface should be strong enough to support a fully loaded refrigerator.
To protect the fi nish of the fl ooring, cut a large section of the cardboard carton and place it under the refrigerator where you are working. When moving the refrigerator, you need to pull and push it straight forwards or back. Do not wiggle it from side to side.
ACCESSORIES AND
REQUIRED TOOLS
The following accessories are included with your refrigerator:
Hex wrench
10_ setting up
REMOVING THE REFRIGERATOR DOORS
For some installations you need to remove the fridge and freezer drawers so you can move the refrigerator to its fi nal location. Do not remove the doors/drawer if you don’t need to. If you do not need to remove the refrigerator doors, go to Adjusting the Level on page 13. If you need to remove the doors. continue below.
Before removing the door/drawer, make sure you read the following items:
Disconnect power to the refrigerator WARNING before removing the door or drawer.
• Be careful not to drop, damage, or
scratch the doors/drawers while removing them.
•Use care when you remove the doors/drawers. The doors are heavy and you could injure yourself.
•Reattach the doors/drawers properly to avoid: - Moisture from air leakage.
- Uneven door alignment.
- Wasting energy due to improper door seal.
Disassemble the refrigerator doors
Be careful not to drop and scratch the WARNING doors while removing them.
2014. 5. 13. 11:46 |
