With the door opened
1.Remove 3 screws holding down the TOP TABLE ( 1 ) and separate wires connected.
1
2.Disconnect two connector ( 2 ) on the left side door. To remove the water coupler from the hinge, twist and pull it from the hinge. Remove the water line ( 3 ) while pressing the marked part ( 4 ) of the water line coupler.
If a red clip is on the coupler, it must be CAUTION removed before removing the tube.
2
Red Clip
(1/4")
3
4
3.Pull and remove the hinge lever ( 5 ) . Remove the ground screw ( 6 ) attached to the upper left door hinges with a philips screwdriver (+). Remove the upper left and right door hinges ( 7 ).
5 | 6 |
|
5.Remove the screw ( 8 ) attached to the lower left and right door hinges with a philips screwdriver (+). Remove the 2 hex head bolts ( 9 ) attached to the lower left and right door hinges with an allen wrench (3/16”). Remove the lower left and right door hinges ( 10 ).
10
8
9
Allen wrench
REATTACHING THE REFRIGERATOR DOORS
To reattach the fridge doors after you have moved the fridge to its fi nal location, assemble the parts in reverse order.
1.The Water Line must be fully inserted to the center of transparent coupler (Type A) or the Guide Lines (Type B) to prevent water leakage from the dispenser.
2.Insert the clip in the install pack and check that it holds the line firmly.
Type A | Type B | |
| Dispenser | |
Center of Transparent coupler | The Guide Lines | |
| ||
clip A (1/4”) | clip A (1/4”) | |
(6.35 mm) | ||
(6.35 mm) | ||
|
7
4.Lift the door straight up to remove.
DISASSEMBLE THE FLEX DOOR
1.Take out the upper drawer by lifting it up.
2.Remove the freeze room guard ( 1 ) by lifting the guard up.
1
08_ setting up
13. 4. 25. �� 2:12 |