MAKING MINOR ADJUSTMENTS BETWEEN DOORS
Remember, a leveled refrigerator is necessary for getting the doors perfectly even. If you need help, review the previous section on leveling the refrigerator.
| Adjustment |
Fixed part | part |
|
The left door is fixed. To make minor adjustments between doors, adjust only the right door.
1.Pull out the freezer drawer ( 1 ) to reveal the lower hinge ( 2 ).
2.Insert the supplied allen wrench (3/16”) ( 3 ) into the shaft ( 4 ) of the lower hinge.
3.Adjust the height by turning the hex wrench ( 3 ) clockwise ( DOWN ) or counter clockwise ( UP ).
When you turn the hex wrench counter-
clockwise (), the door will move up.
2 |
|
3 | 3 |
4 |
|
1
2 fastener are enclosed with the refrigerator. The thickness of each fastener is 0.04”.
INSTALLING THE WATER DISPENSER LINE
A water dispenser with a filter is one of the helpful features on your new refrigerator. To help promote better health, the water filter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms. You may need to purchase a water purifying system to do that. The water line also connects to the ice maker. For the ice maker to operate properly, water pressure of 20~125 psi (138~862 kPa) is required. If the refrigerator is installed in an area with low water pressure (below 20psi), you can install
a booster pump to compensate for the low pressure.
After you have connected the water line, make sure the water storage tank inside the refrigerator is properly filled. To do this, press the water dispenser lever until the water runs from the water outlet.
Water line installation kits are available at extra cost from your dealer.
We recommend using a water line installation kit that contains copper tubing and ¼” compression nut.
Connecting to the water supply line
1.First, shut off the main water
supply.
2.Locate the nearest cold water drinking line and install the pipe clamp and shut off valve.
4.After adjusting the doors, insert the supplied fastener ( 6 ) using a pliers ( 5 ) in the gap between the
Cold water line
Pipe clamp
Shut off valve
3.Connect the water line installation kit to the shut off valve.
10_ setting up
13. 4. 25. |
�� 2:12