Samsung RF4287HABP Assemble the Freezer Drawer, Adjusting the Level, How to adjust the level

ASSEMBLE THE FREEZER DRAWER

To reattach the freezer drawer, assemble parts in reverse order.

ADJUSTING THE LEVEL

Make sure the refrigerator is level so that you can make fi nal adjustments. Use a level to test if the

refi gerator is level both side to side and back to front. If the refrigerator is not level, it will not be possible to get the doors perfectly even, which may cause moisture condensation and increased energy bills. Below is an example of how to level the refrigerator if the left side of the refrigerator is lower than the right side.

How to adjust the level

1.Open the freezer drawer and remove the lower

basket. (See to page 8)	2
2. Remove the two screws
( 1 ) attached to the cover
leg front ( 2 ) with a Philips
screwdriver (+).	1

3. Remove the cover leg front ( 2 ) by lifting the bottom part of the cover leg front up and pulling it out.

4.Insert a fl at-blade screwdriver (-) into a notch on the left control lever, and turn it count clockwise to level the refrigerator. (You turn the lever clockwise to lower the refrigerator and counterclockwise to raise it.)

If the right side is lower, perform the same procedure, but with the right control lever.

It is diffi cult to remove the cover leg front from the refrigerator, so we do not recommend making small adjustments wIth the control lever. Instead, refer to the next page for the best way to make minor adjustments to the doors.

MAKING MINOR ADJUSTMENTS BETWEEN DOORS

Remember, a leveled refrigerator is necessary for getting the doors perfectly even. If you need help, review the previous section on leveling the refrigerator.

Fixed part	Adjustment
	part

The left door is fi xed. To make minor adjustments between doors, adjust only the right door.

1.Pull out the Convertible door ( 1 ) to expose the lower hinge ( 2 ).

2.Insert the supplied allen wrench (3/16”) ( 3 ) into the shaft ( 4 ) of the lower hinge.

3.Please adjust the height by turning the hex wrench ( 3 ) clockwise ( DOWN ) or counter-clockwise ( UP ).

2
3	3
4

1

01 SETTING UP

flat-blade		Control Lever
screwdriver(-)		When you turn the hex wrench counter-
		clockwise (	), the door will move up.
	Both control levers must be touching the fl oor
CAUTION	to avoid possible personal injury or property
	damage because of tipping.

setting up _09

DA68-01922A.indb 09 2013.3.4 1:32:38 PM