•Do not install the refrigerator where the temperature will go below 50ºF (10ºC).
•Do not locate the refrigerator where it may become wet.
When moving your refrigerator
To prevent fl oor damage, be sure the front
CAUTION adjusting legs are in the up position (above the fl oor).
Refer to ‘Adjusting the doors’ in the manual (on page 9).
Hex wrench | Fastener |
Required Tools (Not provided)
You need the following tools to complete the installation of your refi rgerator:
Control Lever | |
screw |
|
FLOORING
For proper installation, this refrigerator must be placed on a leveled surface of hard material that is the same height as the rest of the fl ooring. This surface should be strong enough to support a fully loaded refrigerator, or approximately 359lbs (165kg). To protect the fi nish of the fl ooring, cut a large section of the cardboard carton and place it under the refrigerator where you are working. When moving a refrigerator, you need
to pull and push it straight forwards or back. Do not wiggle it from side to side.
ACCESSORIES AND REQUIRED TOOLS
The following accessories are included with your refi gerator:
Philips screwdriver | Socket wrench | |
(+) | screwdriver | (10mm) |
Pliers | Allen wrench (3/16”) (5mm) |
REMOVING THE REFRIGERATOR DOORS
Some installations require door removal to transport the refrigerator to its fi nal location. Do not remove the door/drawer if you don't need to. If you do not need to remove the refrigerator doors, go to Adjusting the Level on page 8. If you need to remove the doors. continue below.
Before removing the door/drawer, make sure you read the following items:
Disconnect power to the refrigerator before removing the door or drawer.
WARNING
• Be careful not to drop, damage or scratch the door/drawer while removing them.
•Be careful not to get injured while removing the door/drawer.
•Reattach the door/drawer properly to avoid:
-Moisture from air leakage.
-Uneven door alignment.
-Wasting energy due to improper door seal.
06_ setting up
2013.3.4 1:32:32 PM |
