Recommend Temp (Fridge) : 38F
- The temperature of the Freezer, fridge or Convertible Room may rise when you open the doors too frequently, or if a large amount of warm or hot food is placed inside.
-This may cause the digital display to blink. Once the Freezer and fridge temperature return to their normal set temperatures, the blinking will stop.
-If the blinking continues, you may need to “reset” the Refrigerator. Try unplugging the appliance, wait for around 10 minutes and then plug the power cord back in.
-If there is an communication error between the Display and Main Controller, the Convertible Display light may blink. Once the normal set temperatures are reached, the blinking will stop. If the blinking continues for a long period of time, please contact a Samsung Electronics Service Center.
USING THE TWO LEVER DISPENSER
Push the appropriate ice type button to select what you want dispensed.
NO ICE
Select this if you want to turn ice maker off
Using the ice lever ( 1 )
Push the Ice lever dispenser ( 1 )
gently with your glass. Ice will be 1 
released from the dispenser.
You can choose the type of ice by | 2 |
| |
pushing the cubed or crushed button |
|
fi rst. |
|
16_ operating |
|
Using the Water lever ( 2 )
Push the Water lever dispenser ( 2 ) gently with your glass. Water will be released from the dispenser.
Even if you push the water and Ice lever simultaneously, the dispenser operates only the option you selected or pushed fi rst.
Using the Ice & Water Dispenser together
To get Ice and water, push the Ice lever ( 1 ) fi rst for ice, then move your glass down and press the water dispenser lever ( 2 ) for water.
check the water level
Test button
Do not pull the lever out. You could damage CAUTION or break the lever's spring.
•To clean the ice bin/bucket, wash with a mild detergent, rinse well, and dry
CAUTION
thoroughly it. Do not use harsh or abrasive cleaners or solvents.
•When you select Cubed Ice after using the Crushed Ice mode, a small amount of residual crushed ice might be produced.
•In case ice doesn’t come out, pull out the ice bucket and press the test button located on the right side of ice maker.
•Do not press the test button continuously when the tray is fi lled with ice or water. Water may overfl ow or ice may jam the bucket.
•Normal Use
To fi ll the ice bucket to maximum capacity after installation, follow these steps:
1.Allow your refrigerator to operate and cool down for 24 hours (or 1 full day).
-Waiting 24 hours will allow your ice maker to cool properly.
2.Dispense 4 to 6 ice cubes into the glass.
3.After 8, and then 16 hours, dispense a full glass of ice.
2013.3.4 1:33:11 PM |
