No Leak

1.Slip the compression nut ( A ) through the supplied plastic tubing ( A ).

2.Tighten the compression nut ( A ) onto the 1/4”

compression fitting.

-- If you are using copper tubing, slip the compression nut ( B ) (not included) and ferrule (not included) on copper tubing (not included) as shown.

-- If you are using plastic tubing ( B ), insert the molded end (Bulb) of the plastic tubing ( B ) into the compression fitting.

Do not use without the molded end(Bulb) CAUTION of the plastic tubing ( B ).

3.Tighten the compression nut ( B ) onto the compression fitting.

Do not over-tighten the compression nut ( B ).

4.Turn water on and check for any leakage.

Only connect the water line to a drinkable water source.

If you have to repair or disassemble the water line, cut off 1/4“ of the plastic tubing to make sure you get a snug, leak-free connection.

BEFORE USING ICEMAKER

Remove

-- Remove the Icemaker Bucket by lifting it up and pulling it out slowly.

-- Grip the handle as shown in the figure.

-- Remove the Ice Bucket slowly to prevent damage.

Figure 1

Do not use excessive force when removing the drawer cover.

Otherwise, the cover may break and cause injury.

Before removing any accessories, make sure that no food is in the way.

When possible, remove the food altogether to reduce the risk of accidents.

Install

-- Assemble the icemaker in the reverse order of disassembly.

-- Push the bucket in firmly until you hear a clicking sound.

English - 26

DA68-03015D-10.indb 26

2017. 7. 7. �� 2:18