Manuals / Samsung / Computer Equipment / Network Card

Samsung RIF-BT10 user manual Attachment 6. Printer driver installation & Test page printing, V1.00

Models: RIF-BT10

1 17

Page 16

Attachment 6. Printer driver installation & Test page printing

1.Once the setting’s complete, disconnect the Bluetooth master from the PC, reconnect it and initialize the system. Turn the printer off and then on to initialize the Bluetooth slave.

2.Wait for approximately 20 seconds for the Bluetooth master and slave are automatically reconnected.

3.Install the printer driver (Available at website)

a)SRP 350: V3.0.5E above

b)SRP 270: V3.0.3E above

4.Open the printer driver and select a port

a)USB port: Select the virtual port (COM x) of step 2).

b)Serial (RS-232C): Select the COM x connected.

5.Select the port and Click “Apply”.

V1.00

WWW.SAMSUNGMINIPRINTERS.COM

Page 16

Image 16

Samsung RIF-BT10 user manual Attachment 6. Printer driver installation & Test page printing, V1.00

Contents

Table of Contents Bluetooth user manualRIF-BT10 RIF-BT10 RIF-BT10CCableUSBBTCableSerialBT SRP 350 V3.0.5E above SRP 270 V3.0.3E aboveCategory 4 Master can send data to max 7 printers at the same time Refer to Attachment 1.Virtual serial port driver installation Port Setting 19200, 8, none, 1, hardwareAdvanced Setting 4096, 4096, 16, 0 Refer to Attachment 2. Virtual serial port settingRefer to Attachment 5. Bluetooth master Setting “Bluetooth control message1. Connect Bluetooth Master to USB port of PC Attachment 2. Virtual serial port setting 1. Open Device Manager as the below pathStart Control Panel System Hardware Device Manager V1.004. Set as below and apply “OK” 19200 ModelBaud ratebps Hand shaking2. Execute “BluetoothConfigV2.x.exe” 5. Set as below and apply OK. slave, 19200, hardwareAttachment 4. Bluetooth slave setting V1.002. Execute “BluetoothConfigV2.x.exe” Attachment 5. Bluetooth master settingV1.00 6. Select “Register Printers” 7. Select “Search” The printer should be Power ON10. Select “Configure Adapter” and check “auto connect to printers” 9. Click “Close”12. Disconnect the Bluetooth main Master/Slave from the PC 11. Click “OK” and then “Quit” to exit1 Bluetooth address Individual address of each Bluetooth module Attachment 6. Printer driver installation & Test page printing V1.006. Set the port settings as below 19200, 8, none, 1, hardware 7. Click “OK” and then “Close”8. Open the printer drive again and click “Test Page Print” 9. The windows test page prints